|
Hi Mike,
There are two things:
1. Kura hasn't been tested against NOOBS, only Raspian. Let me check on this and get back to you.
2. Can you send details on your WiFi module? Kura depends on tools that leverage the nl80211 interface (ex: iw), which not all chipsets support. A quick check would be to issue the command: iw dev list .
Thanks,
--Dave
-------- Original message --------
From: Mike Milinkovich <mike.milinkovich@xxxxxxxxxxx>
Date:10/19/2014 20:51 (GMT-08:00)
To: kura-dev@xxxxxxxxxxx
Cc:
Subject: Re: [kura-dev] Kura on wlan0
On 19/10/2014 10:53 PM, Mike Milinkovich wrote:
I seem to be having trouble getting my Raspberry Pi+Kura to work over wifi rather than ethernet. In fact, just editing the /etc/network/interfaces file to get wlan0 to use DHCP rather than a static IP address seems to kill the device.
Does anyone have any pointers on what I might be doing wrong here?
Probably unrelated, but I just noticed that I am getting an error when I boot the Pi:
[FAIL] startpar: service(s) returned failure: isc-dhcp-server .... failed
This is on a completely fresh install based on NOOBS 1.3
| 