[
Date Prev][
Date Next][
Thread Prev][
Thread Next][
Date Index][
Thread Index]
[
List Home]
|
Re: [photran] Workbench Bulid Behavior
|
Hello,
Try clicking on the behavior tab in that dialog from the attached screenshot.
Matt
On Thu, Jul 15, 2010 at 8:37 AM, Thomas, Justin W. <jthomas@xxxxxxx> wrote:
> Hello,
>
> I am getting started using Eclipse and Photran, and just upgraded to Eclipse 3.6.0 and Photran 6.0 a couple days ago. I have an existing Fortran program that was originally developed a few decades ago, well before the days of IDEs. I am very close to having it incorporated into Eclipse, but I have this one pesky problem. I would like to be able to use a target other than "all" in my build configuration.
>
> According to the documentation, under the project settings, there are panels for C/C++ Build and Fortran Build preferences. I attached the figure from the documentation (not sure if the attachment will make it through). There is a section in that window for Workbench Build Behavior that enables you to chose what target to make, rather than the default "all". However, when I open the same dialog box, the Workbench Build Behavior section is completely missing.
>
> Any advice? Should I be asking this question to the overall Eclipse group or CDT perhaps?
>
> Many thanks,
>
> Justin
> ___________________________________
> Justin W. Thomas
> Nuclear Engineering Division
> Argonne National Laboratory
> 9700 South Cass Avenue Bldg 208
> Argonne, IL 60439
> Phone: (630) 252-4850
> Fax: (630) 252-3361
>
>
>
>
> _______________________________________________
> photran mailing list
> photran@xxxxxxxxxxx
> https://dev.eclipse.org/mailman/listinfo/photran
>
>
