| RE: [cdt-dev] editing register groups |
|
Mikhail, >What do you mean by that? You can only create a
group when you have a running session. We don't have any information about
registers without getting access to GDB. >As long as it is created it is stored in the
launch configuration. I think you misunderstood me (or I didn’t explain properly).
Here’s what I mean. -
I start a CDI-GDB debug session -
Open Registers view > Add
register group > select some registers > Click on OK, but the register group
doesn’t show up! -
Terminate the debug session -
Launch debug session again, the
register groups that I had added in the previous debug session now show up in
registers view. This is most likely a refreshing issue. I’m running off of trunk so not sure if this is a problem
in my development environment or not. - Navid From: cdt-dev-bounces@xxxxxxxxxxx
[mailto:cdt-dev-bounces@xxxxxxxxxxx] On
Behalf Of Mikhail Khodjaiants On 16/04/2010 4:33 PM, Mehregani, Navid wrote: In fact, I just tried this on CDI-GDB and
it’s not working very well. The newly added register groups don’t show up
until I launch a subsequent debug session! What do you mean by that? You can
only create a group when you have a running session. We don't have any
information about registers without getting access to GDB. As long as it is
created it is stored in the launch configuration. |