[aperi-dev] Aperi R0.3 Release Candidate 1 on SLES 10 with HBA question

[Christoph Reichert <Christoph.Reichert@xxxxxxxxxx>]

aperi-dev-bounces@xxxxxxxxxxx wrote on 15.05.2007 16:49:27:

..


> > Cannot open /etc/hba.conf
>
> This means you don't have a fibre channel HBA in your
> server (it's a warning from SNIA's HBA API libhbaapi.so when
> trying to open your non-existent HBA)
>


There is a HBA installed in the server,
are there any additional steps I need to perform on Linux to get this card
detected by the SNIA HBA?

/var/log/boot.msg:
<5> 0:0:8:0: Attached scsi generic sg1 type 3
<6>QLogic Fibre Channel HBA Driver
<6>ACPI: PCI Interrupt 0000:01:02.0[A] -> GSI 18 (level, low) -> IRQ 177
<6>qla2xxx 0000:01:02.0: Found an ISP2312, irq 177, iobase 0xf8878000
<6>qla2xxx 0000:01:02.0: Configuring PCI space...
<6>qla2xxx 0000:01:02.0: Configure NVRAM parameters...
<6>qla2xxx 0000:01:02.0: Verifying loaded RISC code...
<6>qla2xxx 0000:01:02.0: Waiting for LIP to complete...
<6>qla2xxx 0000:01:02.0: LOOP UP detected (1 Gbps).
<6>qla2xxx 0000:01:02.0: Topology - (F_Port), Host Loop address 0xffff
<4>qla2xxx 0000:01:02.0: SNS scan failed -- assuming zero-entry result...
<6>scsi1 : qla2xxx
<6>qla2xxx 0000:01:02.0:
<4> QLogic Fibre Channel HBA Driver: 8.01.04-k
<4>  QLogic QLA2340 -
<4>  ISP2312: PCI-X (100 MHz) @ 0000:01:02.0 hdma+, host#=1, fw=3.03.18 IPX
<6>ACPI: PCI Interrupt 0000:02:03.0[A] -> GSI 20 (level, low) -> IRQ 185



Mit freundlichen Gren, best regards

Christoph Reichert


Storage Software Development, Eclipse Aperi Project
IBM Deutschland, Mainz, Germany
Phone: +49-6131/84-5962, Fax: -6099
mailto:Christoph.Reichert@xxxxxxxxxx

IBM Deutschland GmbH
Vorsitzender des Aufsichtsrats: Hans Ulrich Maerki
Geschftsfhrung: Martin Jetter (Vorsitzender), Rudolf Bauer, Christian
Diedrich, Christoph Grandpierre, Matthias Hartmann, Thomas Fell, Michael
Diemer
Sitz der Gesellschaft: Stuttgart
Registergericht: Amtsgericht Stuttgart, HRB 14562 WEEE-Reg.-Nr. DE 99369940