Community
Participate
Working Groups
Normally (at least earlier), when using the embedded xtext editor to insert constraints, it was possible to confirm a constraint expression by pressing Ctrl-Enter. This would confirm the constraint, and close the xtext editor. Now pressing Ctrl-Enter does confirm the constraint, but also inserts a newline character at the same time. This is very annoying…
I cannot reproduce the error. I guess you relate to the specification edition via the property view: if I open the specification and press control-enter, the dialog is closed, but there is no additional enter in the specification - at least on my linux machine.
(In reply to Ansgar Radermacher from comment #1) > I cannot reproduce the error. I guess you relate to the specification > edition via the property view: I'm sorry, I should have been more explicit. I did not refer to the edition via the properties, but to the pop-up editor when editing the constraint from the diagram. > if I open the specification and press > control-enter, the dialog is closed, but there is no additional enter in the > specification - at least on my linux machine. FWIW, this also works fine on my mac
I still can reproduce it in 2021-03 in the direct editor but not int he constraint editor (pop-up).