[News.eclipse.technology.gmf] marking of faulty elements in the diagram

[Mathias Kissig <mathias.kissig@xxxxxxxxx>]

Hello everybody,

For enforcing modeling and naming rules I rely heavily on audit rules which are 
executed in live and batch mode. The rules work perfectly, but I have a minor 
problem with the warning and error icons which are attached to the faulty 
elements: All elements are either marked as error (white cross) or as warning 
(yellow warning) even if they are correct.
To clarify things a little bit, consider the following cases:
All elements are correct -> the batch-validation marks no element
All but one element are correct -> after the validation, every (!) element is 
marked as false.

First of all, I thought this might be because of my audit rules, which use lots 
of iterators for the validation. In that case, a comparison between a faulty and 
correct element might have led to an violated rule between those two and so both 
are marked as false. But this is not the case. Even if I disable all iterating 
rules and use just the "check one element" rules, every element is marked.

Has anybody experienced the same behaviour and knows a solutions to this 
problem? Any suggestions and workarounds are welcome.

Thanks in advance for your help and
best regards,
Mathias