[news.eclipse.modeling.gmt.amw] Re: Traceability model does NOT highligh

[m.a.cibran@xxxxxxxxx (Maria Agustina Cibran)]

Thanks, it works now!

Marcos Didonet Del Fabro wrote:

> Hi,

> this happens typically when the path of the woven models is not set up 
> correctly. Check the path of the source and target models in the ".prop" 
> file, and in the weaving model that was produced. The paths should 
> correspond.

> Regards,

> Marcos.

> Maria Agustina Cibran wrote:
> > Hi,
> >
> > I succesfully managed to use AMW to create and load a traceability 
> > model. However, I have a small issue in the visualization of the 
> > traceability metamodel and the corresponding source and target models:
> >
> > when I select an element in the traceability metamodel, the 
> > corresponding element in the source model is highlighted correctly 
> > whereas the corresponding target model element is NOT highlighted. I 
> > used the weaver wizard to load the traceability model, using TraceModel 
> > as the WModel and I add the source and target models in the same way 
> > (both for IN and OUT models: WModelRef=TraceModelRef, 
> > panel=DefaultWovenPanelExtension).
> >
> > I would appreciate if you could give me a hint of how to solve this issue.
> >
> > Thanks in advance,
> > Kind regards,
> > Agustina