[news.eclipse.modeling.gmt.amw] Re: Traceability model does NOT highligh

[Marcos Didonet Del Fabro <mddfabro@xxxxxxx>]

Hi,

this happens typically when the path of the woven models is not set up 
correctly. Check the path of the source and target models in the ".prop" 
file, and in the weaving model that was produced. The paths should 
correspond.

Regards,

Marcos.

Maria Agustina Cibran wrote:
> Hi,
>
> I succesfully managed to use AMW to create and load a traceability 
> model. However, I have a small issue in the visualization of the 
> traceability metamodel and the corresponding source and target models:
>
> when I select an element in the traceability metamodel, the 
> corresponding element in the source model is highlighted correctly 
> whereas the corresponding target model element is NOT highlighted. I 
> used the weaver wizard to load the traceability model, using TraceModel 
> as the WModel and I add the source and target models in the same way 
> (both for IN and OUT models: WModelRef=TraceModelRef, 
> panel=DefaultWovenPanelExtension).
>
> I would appreciate if you could give me a hint of how to solve this issue.
>
> Thanks in advance,
> Kind regards,
> Agustina