[
Date Prev][
Date Next][
Thread Prev][
Thread Next][
Date Index][
Thread Index]
[
List Home]
|
[edt-dev] enable linenumbering in lexer
|
Hello,
in order to keep track of symbol locations
in the lexer, only start- en endoffset are taken into account. Reporting
about source code could be a lot simpeler if line-numbers were taken
into account.
However, in the IDE, linenumbers are
reported in the problem markers. Can you indicate where the mapping between
the offsets from the lexer and the lines in the IDE happens?
Line number reporting is important for
us, also outside of the IDE. If the community agrees, we would like to
contribute this change to have the lexer report the line numbers of symbols.
Yours truly,
Bart Decuypere, Senior System
Engineer
KBC Global Services NV, SSO HILA Unix(LEUBRUST - OOT)
Brusselsesteenweg 100, 3000 Leuven, België
KBC Global Services NV, Havenlaan
2, 1080 Brussel, België, VAT BE 0465.746.488, RLP BrusselsThis e-mail and any attached files are confidential and may be legally privileged. If you are not the addressee, any disclosure, reproduction, copying, distribution, or other dissemination or use of this communication is strictly prohibited. If you have received this transmission in error please notify KBC immediately and then delete this e-mail.
KBC does not accept liability for the correct and complete transmission of the information, nor for any delay or interruption of the transmission, nor for damages arising from the use of or reliance on the information.
All e-mail messages addressed to, received or sent by KBC or KBC employees are deemed to be professional in nature. Accordingly, the sender or recipient of these messages agrees that they may be read by other KBC employees than the official recipient or sender in order to ensure the continuity of work-related activities and allow supervision thereof.
