[cdt-dev] Synergy Eclipse CDT question!

["Figuer, Felipe A" <Felipe.A.Figuer@xxxxxxxxxx>]

Hello all.  I have been using EclipseGalileoSR2forC_C++ with Synergy and Eclipse Integration 3.5.0 for a while.

 

That works quite good for me.

 

Right now I wanted to update to EclipseHeliosforC_C++ but it happens that the “path entry job” gets stuck almost always.  When it does not get stuck I try start the Synergy session and Eclipse hangs forever.

 

My question is then.

 

Is there anything I can do about it? 

 

Or as Eclipse Galileo was 3.5.0 and Helios is 3.6 I have to get a new Synergy plug in for 3.6?

 

Best regards,

 

Felipe Antonio Martinez Figueroa.

+52 442 1030500 Ext.1249.

felipe.a.figuer@xxxxxxxxxx

Delphi Electronics & Safety

Software Development Tools & Expert Synergy User & Suggestions Committee Leader

Queretaro Technical Center.

Circuito Palma Cocotera No. 2059.

Fraccionamiento Palmares.

Queretaro, Qro. CP 76127

Mexico.

****************************************************************************************

Note:  If the reader of this message is not the intended recipient, or an employee or agent responsible for delivering this message to the intended recipient, you are hereby notified that any dissemination, distribution or copying of this communication is strictly prohibited. If you have received this communication in error, please notify us immediately by replying to the message and deleting it from your computer. Thank you. 

****************************************************************************************